calibration block
英 [ˌkælɪˈbreɪʃn blɒk]
美 [ˌkælɪˈbreɪʃn blɑːk]
网络 校准试块; 校准块
双语例句
- The direct calibration method of heavy block calibration is first presented and realized. The structures and controlling circuits of automatic adjusting pendulum and automatic calibration are designed.
首次提出并实现了重块标定的直接标定方法，设计了自动调摆和自动标定机构和控制电路。 - An intelligent calibrator based on new standards for calibration of block gauges and with 8031 single chip computer as its kernel is presented in this paper.
本文介绍了一种按新的量块检定标准研制的以8031单片机为核心的智能检定仪。 - A dynamic calibration experimental scheme is designed in order to study the dynamic characteristics, and a solution of block modeling method is proposed to solve the sensor's dynamic nonlinear problem.
为了研究氧传感器的动态特性，文中设计了动态标定的实验方案，并提出采用块联模型的建模方法解决其动态非线性问题。 - Then the system parameters and kinematical parameters is estimated and a new calibration block is designed, After that the parameters are determined as a result by the least squares method.
在此基础上研究了模型中系统参数及运动参数的标定问题，设计了一种全新的标定块，并使用该标定块根据最小二乘法和迭代法快速地实现了参数标定。 - Based on the research and analysis, application conditions of different methods and main reasons affecting the calculating results are found out. This provides a reasonable base for choosing the recovery calibration method and recovery calculation for complex minor fault block oilfields.
研究分析后，找出了各种方法的应用条件及影响计算结果的主要因素，为合理选用复杂小断块油田采收率的标定方法及取值提供了依据。 - Calibration object-based method can get higher accuracy, but the calibration process is time-consuming. Therefore, calibration object-based method can not be used for online calibration and the situation without calibration block.
其中，基于标定物的方法可以获得较高的精度，但标定过程费时费力，不适用于在线标定和不可能使用标定块的场合。 - According to the stable characteristic of satellite orbits, Direct Calibration Model ( DCM) of exterior orientation parameters was proposed. The structures of error equation and norm equation of the model block adjustment system were analyzed.
针对卫星飞行平稳的特点，提出了外方位直接校正模型，剖析了自检校区域网平差系统的误差方程结构及其法方程结构。 - Second, considering the actual condition, we designed a standard test equipment for calibration test stand, including tanks, defect test block and the ultrasonic probe ring.
其次我们考虑实际工况，设计了标验设备的率定试验台，主要包括水槽、缺陷试块以及超声波探头环。 - According to the two basic components of microscopic simulation model, transportation facility and driver-vehicle unit, the calibration framework can be divided into two parts, named as main program and calibration loop block.
根据微观仿真模型中两个基本组成部分，交通设施和人车单元，校正方法包括校正主程序和校正循环体两个内容。 - Calibration block calibration using cube boxes as incamera calibration, making simple, experimental low requirements.
标定过程中采用立方体标定盒作为摄像机标定块，制作简单，实验要求较低。